Extension cords and portable power strips are for temporary use only and are not to be used as permanent wiring or outlets. If additional outlets are needed they are to be installed. Call the OFS Work Desk (646-7114) to get an installation estimate.

Retail surge protectors are designed for only light loads such as computers, printers, and low amperage equipment. They are not to be used for fans, heaters, coffeemakers, and equipment with similar loads.

Use only surge protectors that have an internal circuit breaker. With these the breaker will trip to prevent fire, if over-loaded or shorted.

All units should be UL (Underwriters Laboratory) or Electrical Testing Laboratories approved.

If the unit or its wiring becomes hot to the touch, immediately remove the unit. The electrical load and the unit need to be checked for overloading.

Surge protectors are not suitable for or to be used in moist areas.

Each surge protector is to be plugged into a outlet and not “daisy-chained or piggy-backed.” This is where a unit is plugged into another surge protector or portable power strip. This practice causes overloading.

Do not locate a surge protector or power strip where the unit would be covered with carpet, furniture or any other item that will limit or prevent air circulation.

Check all surge protectors on a regular basis to ensure that they are not damaged and fully engaged in the outlets.

Never use a three to two prong adapter to power a surge protector or power strip. It should always have a three-prong grounded plug.

All appliances and electric outlet near water should be protected by GFCI units.

Space heaters are to be kept away from any combustible materials such as paper, clothing, and draperies (always keep unit front & back clear). Don't leave unattended or run on an extension cord.